Reply To: wifi usb not detected

Home Page Forums Network Management ZeroShell wifi usb not detected Reply To: wifi usb not detected

#48488

reaperz
Member

Hello

I have just bought Asus USB-N13 USB-wifi. I did buy it specifically since it is supposed wto work in Linux! If I plug it in, I get in log:

[545243.645044] usb 5-4: new high-speed USB device number 2 using ehci-pci
[545243.778798] usb 5-4: New USB device found, idVendor=0b05, idProduct=17ab
[545243.778806] usb 5-4: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[545243.778812] usb 5-4: Product: 802.11n WLAN Adapter
[545243.778816] usb 5-4: Manufacturer: Realtek
[545243.778821] usb 5-4: SerialNumber: 00e04c000001
[545243.797814] cfg80211: World regulatory domain updated:
[545243.797822] cfg80211: DFS Master region: unset
[545243.797825] cfg80211: (start_freq – end_freq @ bandwidth), (max_antenna_gain, max_eirp), (dfs_cac_time)
[545243.797831] cfg80211: (2402000 KHz – 2472000 KHz @ 40000 KHz), (N/A, 2000 mBm), (N/A)
[545243.797836] cfg80211: (2457000 KHz – 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm), (N/A)
[545243.797840] cfg80211: (2474000 KHz – 2494000 KHz @ 20000 KHz), (N/A, 2000 mBm), (N/A)
[545243.797845] cfg80211: (5170000 KHz – 5250000 KHz @ 80000 KHz, 160000 KHz AUTO), (N/A, 2000 mBm), (N/A)
[545243.797850] cfg80211: (5250000 KHz – 5330000 KHz @ 80000 KHz, 160000 KHz AUTO), (N/A, 2000 mBm), (0 s)
[545243.797855] cfg80211: (5490000 KHz – 5730000 KHz @ 160000 KHz), (N/A, 2000 mBm), (0 s)
[545243.797859] cfg80211: (5735000 KHz – 5835000 KHz @ 80000 KHz), (N/A, 2000 mBm), (N/A)
[545243.797864] cfg80211: (57240000 KHz – 63720000 KHz @ 2160000 KHz), (N/A, 0 mBm), (N/A)
[545243.828650] rtl8192cu: Chip version 0x11
[545243.916043] rtl8192cu: MAC address: 34:97:f6:63:8f:cb
[545243.916053] rtl8192cu: Board Type 0
[545243.916281] rtl_usb: rx_max_size 15360, rx_urb_num 8, in_ep 1
[545243.916864] rtl8192cu: Loading firmware rtlwifi/rtl8192cufw_TMSC.bin
[545243.922651] ieee80211 phy0: Selected rate control algorithm ‘rtl_rc’
[545243.925800] usbcore: registered new interface driver rtl8192cu
[545243.928447] usbcore: registered new interface driver rtl8xxxu

But I don’t see anything in Zeroshell web interface. I restarted my Zeroshell router, still no change!

Is there any simple way to get this USB-WIFI working? Or what would be readily available USB WIFI dongle, that works with Zeroshell?

I don’t want to use it as a repeater, I want to connect to my 4G WIFI pocket router Huawei e5577, as a backup connection. Can’t use 4G USB dongle, Zeroshell does not support it!