Reply To: Possible to specify inbound and outbound bandwith in qos?

Home Page Forums Network Management ZeroShell Possible to specify inbound and outbound bandwith in qos? Reply To: Possible to specify inbound and outbound bandwith in qos?

#45967

ajl37
Member

I think 🙂 (I run a bridged symetrical 100M line) that if you set the global bandwith of eth2 to 768kps it should be fine. You can keep the global bandwidth of the eth0 & 1 cards at 100, but when you set your bandwidth for each QoS class you can set them as you need them

I guess you don’t need to worry about the incoming bandwidth in total as you could set the source & destination in the classifier. Set a class for traffic coming to/from any of your internal ranges to unlimited or even a guaranteed amount, anything coming into your internal networks could be limited. Just a thought.

You may also this useful, rather than my ramblings:
http://vonage.nmhoy.net/qos.html

Andrew