Home Page › Forums › Network Management › ZeroShell › Possible to specify inbound and outbound bandwith in qos? › Reply To: Possible to specify inbound and outbound bandwith in qos?
Close assumption, sorry for being too vauge, as I am new to QoS and did not realize what would be pertinent information.
MY SETUP:
eth0: 10.10.8.0/24 connected to wireless AP (100Mbps ethernet to 108Mbps wireless)
eth1: 10.10.10.0/24 connected to switched LAN (100Mbps ethernet)
eth2: DHCP connected to cable modem (100Mbps ethernet connected to 8Mbps downstream 768kbps upstream cable)
10.10.9.0/24 IPSEC/L2TP VPN (Client to Host)
10.10.11.0/24 OpenVPN VPN (Client to Host)
If what you say about QoS is that it affects the outgoing speeds, I should set my eth2 to 768kbps, my eth0,1 to 8mbps to match the cable modem, but i do not want to limit internal speeds on my network to 8mbps. Suggestions or corrections?
EDIT: No bridging, all routing between subnets, only NAT is to eth2 WAN