Reply To: Can not Bridge VLAN

Home Page Forums Network Management ZeroShell Can not Bridge VLAN Reply To: Can not Bridge VLAN

#45104

Wilfrid
Member

Yes, it allows to tag or untag traffic. The datagrams received with a tag 4 on eth0 are sent on eth1 without the tag and the datagrams received on eth1 are sent with a tag 4 on eth0.

I found the following workaround:
1. on Web Interface:
VLAN 4 sur ETH00 in Network
You don’t see ETH00.4 in bridge creation

2. On CLI:
loadkeys fr
cd /var/register/system/net/interfaces/
ln -s ETH00/VLAN/4 ETH00.4

3. On Web Interface:
Now, you see ETH00.4 in bridge creation
Bridge on ETH01 and ETH00.4 in Network

It works. But when it starts, it do not find ETH00.4 and bridge creation fails. So, I need valid bridge after every start on Web Interface:
In Network, configure BRIDGE00 and confirm

PS: Is there a way to save keymaps? I need to after every start to do “loadkeys fr” in CLI (I try to modify loadkeys config file but the modification is erased after a reboot)

Regards.
Wilfrid