Re: 01 Jun 2014

Home Page Forums Network Management ZeroShell FS Issues Re: 01 Jun 2014

#53456

00:45:56 [ 6.698558] e1000e: Copyright(c) 1999 – 2012 Intel Corporation.
00:45:56 [ 6.698595] e1000e 0000:02:00.0: Disabling ASPM L0s L1
00:45:56 [ 6.698778] e1000e 0000:02:00.0: (unregistered net_device): Interrupt Throttling Rate (ints/sec) set to dynamic conservative mode
00:45:56 [ 6.698891] e1000e 0000:02:00.0: irq 44 for MSI/MSI-X
00:45:56 [ 6.698906] e1000e 0000:02:00.0: irq 45 for MSI/MSI-X
00:45:56 [ 6.698920] e1000e 0000:02:00.0: irq 46 for MSI/MSI-X
00:45:56 [ 6.713215] r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
00:45:56 [ 6.713371] r8169 0000:05:00.0: irq 47 for MSI/MSI-X
00:45:56 [ 6.719226] r8169 0000:05:00.0: eth0: RTL8168e/8111e at 0xf8108000, d8:9d:b9:00:10:83, XID 0c200000 IRQ 47
00:45:56 [ 6.719235] r8169 0000:05:00.0: eth0: jumbo features [frames: 9200 bytes, tx checksumming: ko]
00:45:56 [ 6.719262] r8169 Gigabit Ethernet driver 2.3LK-NAPI loaded
00:45:56 [ 6.719419] r8169 0000:06:00.0: irq 48 for MSI/MSI-X
00:45:56 [ 6.724919] r8169 0000:06:00.0: eth1: RTL8168e/8111e at 0xf810a000, d8:9d:b9:00:10:84, XID 0c200000 IRQ 48
00:45:56 [ 6.724928] r8169 0000:06:00.0: eth1: jumbo features [frames: 9200 bytes, tx checksumming: ko]
00:45:56 [ 6.754600] iTCO_vendor_support: vendor-support=0
00:45:56 [ 6.756660] iTCO_wdt: Intel TCO WatchDog Timer Driver v1.07
00:45:56 [ 6.760479] iTCO_wdt: Found a NM10 TCO device (Version=2, TCOBASE=0x0460)
00:45:56 [ 6.762634] iTCO_wdt: initialized. heartbeat=30 sec (nowayout=0)
00:45:56 [ 6.824592] e1000e 0000:02:00.0: eth2: (PCI Express:2.5GT/s:Width x1) 00:22:4d:a4:81:50
00:45:56 [ 6.824601] e1000e 0000:02:00.0: eth2: Intel(R) PRO/1000 Network Connection
00:45:56 [ 6.824621] e1000e 0000:02:00.0: eth2: MAC: 3, PHY: 8, PBA No: FFFFFF-0FF
00:45:56 [ 6.824644] e1000e 0000:01:00.0: Disabling ASPM L0s L1
00:45:56 [ 6.824835] e1000e 0000:01:00.0: (unregistered net_device): Interrupt Throttling Rate (ints/sec) set to dynamic conservative mode
00:45:56 [ 6.824960] e1000e 0000:01:00.0: irq 49 for MSI/MSI-X
00:45:56 [ 6.824975] e1000e 0000:01:00.0: irq 50 for MSI/MSI-X
00:45:56 [ 6.824989] e1000e 0000:01:00.0: irq 51 for MSI/MSI-X
00:45:56 [ 6.886322] coretemp coretemp.0: Unable to read TjMax from CPU 0
00:45:56 [ 6.886351] coretemp coretemp.0: Unable to read TjMax from CPU 1
00:45:56 [ 6.937980] e1000e 0000:01:00.0: eth3: (PCI Express:2.5GT/s:Width x1) 00:22:4d:a4:81:54
00:45:56 [ 6.937988] e1000e 0000:01:00.0: eth3: Intel(R) PRO/1000 Network Connection
00:45:56 [ 6.938007] e1000e 0000:01:00.0: eth3: MAC: 3, PHY: 8, PBA No: FFFFFF-0FF
00:45:56 [ 7.827937] kjournald starting. Commit interval 5 seconds
00:45:56 [ 7.827975] EXT3-fs (sda1): mounted filesystem with ordered data mode
00:45:56 [ 8.055528] EXT3-fs (sda4): error: unable to read superblock
00:45:56 [ 8.076237] isofs_fill_super: bread failed, dev=sda4, iso_blknum=16, block=32
00:45:56 [ 8.100330] UDF-fs: error (device sda4): udf_read_tagged: read failed, block=256, location=256
00:45:56 [ 8.100653] UDF-fs: error (device sda4): udf_read_tagged: tag version 0x0000 != 0x0002 || 0x0003, block 0
00:45:56 [ 8.100670] UDF-fs: error (device sda4): udf_read_tagged: read failed, block=512, location=512
00:45:56 [ 8.100677] UDF-fs: error (device sda4): udf_read_tagged: tag version 0x0000 != 0x0002 || 0x0003, block 0
00:45:56 [ 8.100683] UDF-fs: error (device sda4): udf_read_tagged: tag version 0x0000 != 0x0002 || 0x0003, block 0
00:45:56 [ 8.100689] UDF-fs: warning (device sda4): udf_load_vrs: No anchor found
00:45:56 [ 8.100694] UDF-fs: Rescanning with blocksize 2048
00:45:56 [ 8.100741] UDF-fs: error (device sda4): udf_read_tagged: read failed, block=256, location=256
00:45:56 [ 8.100752] UDF-fs: error (device sda4): udf_read_tagged: read failed, block=512, location=512
00:45:56 [ 8.100757] UDF-fs: warning (device sda4): udf_load_vrs: No anchor found
00:45:56 [ 8.100762] UDF-fs: warning (device sda4): udf_fill_super: No partition found (1)
00:45:56 [ 8.191459] EXT4-fs (sda5): mounted filesystem with ordered data mode. Opts: (null)
00:45:56 [ 8.452495] EXT4-fs (sdb1): mounted filesystem with ordered data mode. Opts: (null)
00:45:56 [ 8.809293] EXT4-fs (sdb1): mounted filesystem with ordered data mode. Opts: (null)
00:45:56 [ 36.883513] ip_tables: (C) 2000-2006 Netfilter Core Team
00:45:56 [ 36.966082] EXT4-fs (sdb1): re-mounted. Opts: (null)
00:45:56 [ 39.609515] Adding 131068k swap on /DB/swap-file. Priority:-1 extents:1 across:131068k SS
00:45:56 [ 39.927578] c_rehash used greatest stack depth: 5808 bytes left
00:45:56 [ 41.701353] warning: `named’ uses 32-bit capabilities (legacy support in use)
00:45:56 [ 42.146926] nf_conntrack: falling back to vmalloc.
00:45:56 [ 42.251714] ctnetlink v0.93: registering with nfnetlink.
00:46:06 [ 52.115772] Bridge firewalling registered
00:46:06 [ 52.157782] tun: Universal TUN/TAP device driver, 1.6
00:46:06 [ 52.157793] tun: (C) 1999-2004 Max Krasnyansky
00:46:06 [ 52.245751] bonding: Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
00:46:07 [ 53.178435] r8169 0000:05:00.0: ETH00: link down
00:46:07 [ 53.178456] r8169 0000:05:00.0: ETH00: link down
00:46:07 [ 53.179257] ADDRCONF(NETDEV_UP): ETH00: link is not ready
00:46:07 [ 53.502093] r8169 0000:06:00.0: ETH01: link down
00:46:07 [ 53.502535] ADDRCONF(NETDEV_UP): ETH01: link is not ready
00:46:07 [ 53.626979] ADDRCONF(NETDEV_UP): ETH02: link is not ready
00:46:07 [ 53.777123] ADDRCONF(NETDEV_UP): ETH03: link is not ready
00:46:07 [ 53.857521] 8021q: 802.1Q VLAN Support v1.8
00:46:07 [ 53.857547] 8021q: adding VLAN 0 to HW filter on device ETH02
00:46:07 [ 53.857580] 8021q: adding VLAN 0 to HW filter on device ETH03
00:46:07 [ 53.873289] ADDRCONF(NETDEV_UP): ETH03.10: link is not ready
00:46:07 [ 53.963873] ADDRCONF(NETDEV_UP): ETH03.20: link is not ready
00:46:08 [ 54.038978] ADDRCONF(NETDEV_UP): ETH03.50: link is not ready
00:46:08 [ 54.115171] ADDRCONF(NETDEV_UP): ETH03.555: link is not ready
00:46:08 [ 54.316219] ADDRCONF(NETDEV_UP): ETH03.90: link is not ready
00:46:08 [ 54.482534] ADDRCONF(NETDEV_UP): ETH03.99: link is not ready
00:46:08 [ 54.851180] r8169 0000:05:00.0: ETH00: link up
00:46:08 [ 54.852196] ADDRCONF(NETDEV_CHANGE): ETH00: link becomes ready
00:46:10 [ 56.125822] ADDRCONF(NETDEV_UP): VPN99: link is not ready
00:46:10 [ 56.840042] e1000e: ETH03 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx
00:46:10 [ 56.840578] ADDRCONF(NETDEV_CHANGE): ETH03: link becomes ready
00:46:10 [ 56.841203] ADDRCONF(NETDEV_CHANGE): ETH03.10: link becomes ready
00:46:10 [ 56.841830] ADDRCONF(NETDEV_CHANGE): ETH03.20: link becomes ready
00:46:10 [ 56.842457] ADDRCONF(NETDEV_CHANGE): ETH03.50: link becomes ready
00:46:10 [ 56.843312] ADDRCONF(NETDEV_CHANGE): ETH03.90: link becomes ready
00:46:10 [ 56.844082] ADDRCONF(NETDEV_CHANGE): ETH03.99: link becomes ready
00:46:10 [ 56.844810] ADDRCONF(NETDEV_CHANGE): ETH03.555: link becomes ready
00:46:15 [ 61.217385] NET: Registered protocol family 15
00:46:16 [ 62.684505] ADDRCONF(NETDEV_CHANGE): VPN99: link becomes ready
00:46:19 [ 65.078685] ETH00: no IPv6 routers present
00:46:20 [ 66.856895] ETH03.10: no IPv6 routers present
00:46:20 [ 66.868880] ETH03.50: no IPv6 routers present
00:46:20 [ 66.932821] ETH03.99: no IPv6 routers present
00:46:20 [ 66.940806] ETH03.90: no IPv6 routers present
00:46:21 [ 67.116633] ETH03.555: no IPv6 routers present
00:46:21 [ 67.204542] ETH03: no IPv6 routers present
00:46:21 [ 67.763975] ETH03.20: no IPv6 routers present
00:46:22 [ 68.251491] dummy1: no IPv6 routers present
00:46:27 [ 73.214478] VPN99: no IPv6 routers present
00:46:49 [ 94.992118] squid used greatest stack depth: 5648 bytes left